• PARTICLE FILTER TOP
• Introduction example
• Compressor Drain Oil Removal Equipment
• Received outstanding performance awards

Compressor Drain Oil Removal Equipment

Characteristic

1. Waste water is stored in the tank simply by connecting to the drain hose. (Hygiene Control)
2. Automatic operation is possible by the fluid level sensor. (No fear of overflow)
3. With a stirring shower that disperse oil content. (Prolong the life of filter)
4. Particle filters enable waste water to drain 　 directly. (5mg/L)

Specification

	AWK-2501/2Q34 250L Type	AWK-B2501/2Q34 250L Big Type	AWK-5001/2Q34 500L Type
Process Capacity	4 - 6L/min	10L/min	8 - 12L/min
Oil Content after process	5mg/L or below
Process Method	With Particle Filter (A) (B)
Process Amount (100mg/L)	About 1,000L	About 1,500 - 2,000L	About 2,000L
Life Time (Time for Replacement)	When waste water discharge was lowered. When Nanometer shows 0.2MPA. Oil content after processing is 5mg/L or over. (visual)
Used Filter	Used filter should be disposed as an industrial waste.
Installation Location	Keep out of direct sunlight, rain and wind (Movable)
Connecting diameter	3/4 inch
Equipment Size	570 X 750 X 1140 or below
Equipment Configuration	Storage Tank Capacity 130L, Usable Capacity: 110L Filter Pump, Industrial waste water oil removal filter, control switch and so on.

Remarks

1. Processing amount changes entirely depending on the oil content. The amounts shown on the above table are only a guideline and they are not our guaranteed value. Please use them as reference.
2. Lifetime of Industrial Waste Water Oil Removal Filter (A) (B) can vary according to the operation time, lubricant oil to be used and the oil content.
3. Please use this equipment only for the purpose of removing oil from compressor drain
4. Do not put oil into the compressor drain waste water supply port.
5. The value on the above table shows standard value of screw compressor.